Recall Notice - Savage Arms B.Mag Bolt (17 WSM)Voir en Français
August 24, 2015
Savage Arms has discovered that the bolt on some B.MAG rifles may inadvertently catch the safety button and slide it forward into the "fire" position. This condition is primarily present if downward pressure is applied to the bolt too early while pushing it forward. While Savage has received no reports of accidents due to this condition, we have decided to offer free retrofits of all B.MAG rifle bolts out of an abundance of caution and in our ongoing commitment to quality and safety.
To avoid possible unintentional discharge or injury, do not use your B.MAG rifle until your bolt has been retrofitted with a new bolt handle and cap. For instructions on receiving your free bolt retrofit, see the information below. The bolt retrofit includes the replacement of the existing bolt handle and bolt cap with a revised bolt handle and bolt cap. The correct, revised parts are easily identified in the images below.
Products Affected By RecallSavage Arms B.MAG Rifle Bolts
What You Need to DoTo avoid possible unintentional discharge or injury, do not use your B.MAG rifle until your bolt has been retrofitted with a new bolt handle and cap.
- Determine if the bolt is subject to the recall
- If the serial number matches the recall, you can request your free retrofit kit or send back to Savage Arms to be replaced at no cost to you.
Left: Existing bolt handle. Right: Revisited bolt handle with detent mark on arm.
Left: Existing tapered bolt cap. Right: Revisited blunt bolt cap.To avoid serious injury or death with any rifle, observe these precautions:
- Always visually confirm that the safety is on after closing the bolt.
- Never put your finger on the trigger until you are ready to fire.
- Never point a firearm—either loaded or empty—at anything you do not intend to shoot.
ResourcesWritten Retrofit Instructions (.pdf)
Frequently Asked Questions (.pdf)